Design Requirement and Use of Safety in Rubber stamping Die

Rubber stamping die punch processing may be the primary process equipment, rubber stamping parts is on, underneath the relative movement from the mold to accomplish. Because the processing from the lower and upper molds still divide and shut, when the operator's fingers still enter or remain in the mold closed area, it'll pose a significant threat to their own personal safety. (A) the primary areas of the mold, the function and safety needs 1. Work parts Punch die is straight to the blank developing the significant parts punch review, therefore, it's a key area of the mold. (2) the fabric as well as heat treatment ought to be appropriate needs to avoid the hardness is simply too high and brittle christmas punch with alcohol. (2) the punching die isn't just precise and sophisticated, it ought to satisfy the following needs: (1) must have sufficient strength, away from the rubber stamping procedure for fracture or damage crack.

2. Positioning parts Positioning parts would be to determine the position of the installing of the blank parts, a positioning pin (plate), block material pin (plate), Pilot pin, guide plate, distance in the knife. Design positioning parts should be thought about simple to operate, tthere shouldn't be positioning, place to facilitate observation, it is advisable to use forward positioning, profile positioning and Positioning Positioning and so forth. 3. Binder, discharge and discharge parts Binder parts are blank holder, pressure plate and so forth. The blank holder can press the blank holder from the blank holder to avoid the billet from being wrinkled by tangential pressure.

The part from the blanking plate would be to avoid the blank motionless and bouncing. Ejector, the function from the discharge plate is simple to from pieces and cleanup waste. They're spring, rubber and equipment on air cushion push fishing rod support, can progress and lower, ejector design must have enough ejection pressure, movement ought to be limited. The stripper plate will be closed as near as you possibly can towards the empty area or perhaps in the operating position punch using ginger ale. Uncovered discharge plate ought to be outfitted having a protective plate around to avoid finger transmission or foreign objects in to the uncovered surface edges and corners ought to be blunt.